surface finish การใช้

• Magnesium and aluminium alloys usually have a RMS or better surface finish.
• Epoxies also allow shorter cure cycles, increased durability, and improved surface finish.
• The surface finish is very good, usually between 150 and 125 rms.
• However, this increases the thread's yield strength, surface finish, hardness, and wear resistance.
• The surface finish of the casting is as good as the mould surface.
• "' Stamped concrete "'is an architectural concrete which has a superior surface finish.
• The cut motion is designed to give a uniform, smooth, semi-bright surface finish.
• The method chosen depends on the required quality of surface finish.
• In engineering, this is what is usually meant by " surface finish ".
• Other than the surface finish it is essentially a US rifle.
• Chrome plating is a relatively common variation on surface finish for commercial griddles.
• Laser-drilled vias typically have an inferior surface finish inside the hole.
• The semi-finishing teeth provide surface finish and the finishing teeth provide the final finishing.
• Because of the resin and finer sand, it gives a much finer surface finish.
• Unlike Ban Chiang, Ban Kao's wares were thinner and had a glossy surface finish.
• For instance when making a rough cut, the surface finish is of no importance.
• The color motion gives a clean, bright, shiny surface finish.
• In general, the cost of manufacturing a surface increases as the surface finish improves.
• The typical surface finish is 2 4 um ( 75 150 uin ) RMS.
• It is used to decrease the diameter, improve surface finish and improve dimensional accuracy.